Review of Rebell Seaskip II
Basic specs.
Looking for a new boat? Find a Rebell Seaskip II or similar boat for sale
The Rebell Seaskip II is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.
Unknown keel type
The boat can enter even shallow marinas as the draft is just about 1.20 - 1.30 meter (3.94 - 4.24 ft) dependent on the load. See immersion rate below.
The boat may be equipped with an inboard engine
The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Rebell Seaskip II is 2.21, indicating that this boat would not be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Rebell Seaskip II is about 124 kg/cm, alternatively 698 lbs/inch.
Meaning: if you load 124 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 698 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Rebell Seaskip II is 3.10.
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 7.6 m | (24.9 feet) | 10 mm | (3/8 inch) |
| Genoa sheet | 7.6 m | (24.9 feet) | 10 mm | (3/8 inch) |
| Mainsheet | 19.0 m | (62.3 feet) | 10 mm | (3/8 inch) |
| Spinnaker sheet | 16.7 m | (54.9 feet) | 10 mm | (3/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Rebell Seaskip II it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.