Review of Kirby Torch

Basic specs.

The Kirby Torch is a small sailing dinghy designed by the Canadian maritime architect Bruce Kirby in the mid 2010. Several hundred boats have been produced.

Here we would have liked to show you nice photos of the Kirby Torch.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Kirby Torch or similar boat for sale

Hull

The hull is made of plywood.
Some boats has a hull made of Fibreglass.

Rig

The Kirby Torch is equipped with a cat rig. A cat rig (also called an una rig) is simple to manage as there is no standing rigging, often referred to as “unstayed”. With only one sail it can be single-handed quite easily. The downside is its upwind performance.

Keel

DaggerBoard aka Sword

The Kirby Torch is equipped with a daggerboard keel. A daggerboard is a lifting keel that can be lowered and raised, allowing the boat to enter shallow waters as well.

The boat can sail close to the beach as the draft is just 0.10 - 0.20 meter (0.33 - 0.63 ft) dependent of the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Kirby Torch is about 36 kg/cm, alternatively 203 lbs/inch.
Meaning: if you load 36 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 203 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Kirby Torch is 3.09.

Compared with other similar dinghies it is slimmer than 92% of all other designs. It seems that the designer has chosen a significantly more speedy hull design. This type of design is also referred to as 'needle'.

Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Kirby torch it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.