Review of Finnrose P38
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Finnrose P38 or similar boat for sale
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.
The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with one cabin, 6 berths, a galley, 260.0 liter fresh water capacity and toilet facility.
The Finnrose P38 is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.
Unknown keel type
The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.
The boat can enter most marinas as the draft is just about 1.55 - 1.65 meter (5.09 - 5.39 ft) dependent on the load. See immersion rate below.
Finnrose P38 may be equipped with an inboard Yanmar diesel engine at 35 hp (26 kW). The speed is 8.0 knots.
The transmission is a saildrive.
The fuel tank has a capacity of 230.0 liters (60 US gallons, 50 imperial gallons).
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Finnrose P38 is 1.77, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Finnrose P38 is about 254 kg/cm, alternatively 1426 lbs/inch.
Meaning: if you load 254 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1426 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Finnrose P38 is 3.39.
The ballast ratio for Finnrose P38 is 36%.
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 11.3 m | (37.2 feet) | 14 mm | (0.55 inch) |
| Genoa sheet | 11.3 m | (37.2 feet) | 14 mm | (0.55 inch) |
| Mainsheet | 28.4 m | (93.1 feet) | 14 mm | (0.55 inch) |
| Spinnaker sheet | 25.0 m | (81.9 feet) | 14 mm | (0.55 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Finnrose P38 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.