Review of J 10
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a J 10 or similar boat for sale
The boat equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a genaker or a spinnaker for optimal speed.
Unknown keel type
The keel is made of iron. Many people prefer lead keel in favour of iron. The main argument is that lead is much heavier than iron and a lead keel can therefore be made smaller which again result in less wet surface, i.e. less drag. In fact iron is quite heavy, just 30% less heavy than lead, so the advantage of a lead keel is often overstated.
The boat can enter even shallow marinas as the draft is just about 0.74 - 0.84 meter (2.43 - 2.73 ft) dependent on the load. See immersion rate below.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for J 10 is 2.27, indicating that this boat would not be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for J 10 is about 63 kg/cm, alternatively 356 lbs/inch.
Meaning: if you load 63 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 356 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for J 10 is 2.63.
The ballast ratio for J 10 is 38%.
What is Relative Speed Performance?
The Relative Speed Performance for J 10 is 5
Maintenance
Dimensions of sail for fractional rig.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Mainsail halyard | 16.3 m | (53.5 feet) | 6 mm | (1/4 inch) |
| Jib/genoa halyard | 16.3 m | (53.5 feet) | 6 mm | (1/4 inch) |
| Spinnaker halyard | 16.3 m | (53.5 feet) | 6 mm | (1/4 inch) |
| Jib sheet | 5.0 m | (16.4 feet) | 8 mm | (5/16 inch) |
| Genoa sheet | 5.0 m | (16.4 feet) | 8 mm | (5/16 inch) |
| Mainsheet | 12.5 m | (41.0 feet) | 8 mm | (5/16 inch) |
| Spinnaker sheet | 11.0 m | (36.1 feet) | 8 mm | (5/16 inch) |
| Cunningham | 2.4 m | (7.9 feet) | 6 mm | (1/4 inch) |
| Kickingstrap | 4.8 m | (15.7 feet) | 6 mm | (1/4 inch) |
| Clew-outhaul | 4.8 m | (15.7 feet) | 6 mm | (1/4 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for J 10 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.