The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.
The boat is equipped with 416.0 liter fresh water capacity.
The Catalina 400 Mk II is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.
The Catalina 400 Mk II has been built with different keel alternatives.
Fin keel
The Catalina 400 Mk II is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.
The boat can only enter major marinas as the draft is about 2.11 - 2.21 meter (6.92 - 7.22 ft) dependent on the load. See immersion rate below.
Wing keel
But be aware that even though a Wing Keel keel is very good for speed racing, a fishing nets and the like in the water can easily make you into a troublesome situation.
Catalina 400 Mk II can enter most marinas as the draft is just about 1.75 - 1.85 meter (5.74 - 6.04 ft) dependent on the load. See immersion rate below.
The boat may be equipped with an inboard Yanmar 4JH3-BE diesel engine at 56 hp (41 kW). Calculated max speed is about 7.6 knots
The fuel tank has a capacity of 132.0 liters (34 US gallons, 29 imperial gallons).
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Catalina 400 Mk II is 2.00, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
What is Theoretical Maximum Hull Speed?
The theoretical maximal speed of a displacement boat of this length is 8.1 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Catalina 400 Mk II is about 306 kg/cm, alternatively 1716 lbs/inch.
Meaning: if you load 306 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1716 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is Motion Comfort Ratio (MCR)?
The Motion Comfort Ratio for Catalina 400 Mk II is 25.0.
What is L/B (Length Beam Ratio)?
The l/b ratio for Catalina 400 Mk II is 3.00.
The ballast ratio for Catalina 400 Mk II is 40%.
What is Displacement Length Ratio?
The DL-ratio for Catalina 400 Mk II is 180 which categorizes this boat among 'light racers'.
What is SA/D (Sail Area Displacement ratio)?
The SA/D for Catalina 400 Mk II with ISO 8666 reference sail is 17.7, with a 135% genua the SA/D is 20.8.
When buying anti-fouling bottom paint, it's nice to know how much to buy.
The surface of the wet bottom is about 52m2 (559 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.
Note: If you use a paint roller you will need more paint than if you use a paintbrush.
Dimensions of sail for masthead rig.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
Usage | Length | Diameter | ||
Mainsail halyard | 37.1 m | (121.8 feet) | 12 mm | (1/2 inch) |
Jib/genoa halyard | 37.1 m | (121.8 feet) | 12 mm | (1/2 inch) |
Spinnaker halyard | 37.1 m | (121.8 feet) | 12 mm | (1/2 inch) |
Jib sheet | 12.3 m | (40.5 feet) | 14 mm | (0.55 inch) |
Genoa sheet | 12.3 m | (40.5 feet) | 14 mm | (0.55 inch) |
Mainsheet | 30.9 m | (101.2 feet) | 14 mm | (0.55 inch) |
Spinnaker sheet | 27.1 m | (89.1 feet) | 14 mm | (0.55 inch) |
Cunningham | 5.2 m | (17.0 feet) | 12 mm | (1/2 inch) |
Kickingstrap | 10.4 m | (34.0 feet) | 12 mm | (1/2 inch) |
Clew-outhaul | 10.4 m | (34.0 feet) | 12 mm | (1/2 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Catalina 400 Mk II it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.