Review of KMV 2300

Basic specs.

The KMV 2300 is a small motorboat designed by the Norwegian maritime architect Eivind Amble in the late eighties. The KMV 2300 is built by the Norwegian yard KMV Boats A/S.

Here we would have liked to show you nice photos of the KMV 2300.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a KMV 2300 or similar boat for sale

Hull

Both the hull and the deck is made of hand laid fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

Interior

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with one cabin, 4+2 berths, a galley, 70.0 liter fresh water capacity and toilet facility.

Keel

Unknown keel type

The boat can enter even shallow marinas as the draft is just about 0.50 - 0.60 meter (1.64 - 1.94 ft) dependent on the load. See immersion rate below.

Engine

KMV 2300 may be equipped with an inboard MerCruiser engine at 180 hp (134 kW). The speed is 35.0 knots.

The transmission is a Z-drive aka sterndrive.

The fuel tank, which is made of stainless steel, has a capacity of 280.0 liters (73 US gallons, 61 imperial gallons).

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for KMV 2300 is about 117 kg/cm, alternatively 656 lbs/inch.
Meaning: if you load 117 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 656 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for KMV 2300 is 2.80.

Compared with other similar motor boats it is more spacy than 50% of all other designs. It seems that the designer has chosen an average hull design.

Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Danish definition of a powerboat

According to this definition this boat is categorized as a Powerboat.

Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for KMV 2300 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.