Review of Trintella 45

Basic specs.

The Trintella 45 is a large sailboat designed by the Dutch maritime architect E. G. van de Stadt. The Trintella 45 is built by the Dutch yard Wever B.V., Anne, Jachtwerf.

Here we would have liked to show you nice photos of the Trintella 45.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Trintella 45 or similar boat for sale

Interior

The boat is equipped with 6 berths.

Keel

Unknown keel type

The boat can only enter major marinas as the draft is about 1.90 - 2.00 meter (6.23 - 6.53 ft) dependent on the load. See immersion rate below.

Engine

Trintella 45 may be equipped with an inboard diesel engine at 71 hp (52 kW).

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Trintella 45 is 1.61, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Trintella 45 is about 376 kg/cm, alternatively 2107 lbs/inch.
Meaning: if you load 376 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 2107 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Trintella 45 is 3.34.

Compared with other similar sailboats it is more spacy than 58% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.

SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Trintella 45 with ISO 8666 reference sail is 14.1, with a 135% genua the SA/D is 16.7.

The SA/D ratio indicates that it is faster than 3% of all similar sailboat designs in light wind.

Maintenance

Rig

Dimensions of sail.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Mainsail halyard	40.9 m	(134.3 feet)	14 mm	(0.55 inch)
Jib/genoa halyard	40.9 m	(134.3 feet)	14 mm	(0.55 inch)
Spinnaker halyard	40.9 m	(134.3 feet)	14 mm	(0.55 inch)
Jib sheet	13.7 m	(44.9 feet)	16 mm	(5/8 inch)
Genoa sheet	13.7 m	(44.9 feet)	16 mm	(5/8 inch)
Mainsheet	34.2 m	(112.4 feet)	16 mm	(5/8 inch)
Spinnaker sheet	30.1 m	(98.9 feet)	16 mm	(5/8 inch)
Cunningham	5.3 m	(17.5 feet)	14 mm	(0.55 inch)
Kickingstrap	10.7 m	(35.0 feet)	14 mm	(0.55 inch)
Clew-outhaul	10.7 m	(35.0 feet)	14 mm	(0.55 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Trintella 45 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.