YachtDatabase.com

Review of Scand 8600 Dynamic


Scand 8600 Dynamic
Scand 8600 Dynamic.

Basic specs.

sail specifications
The Scand 8600 Dynamic is a motorboat designed by the Norwegian maritime architect Alf Jensen in the late eighties. The Scand 8600 Dynamic is built by the Norwegian yard Scand Boats A/S.

Looking for a new boat? Find a Scand 8600 Dynamic or similar boat for sale

Hull

The hull is made of hand laid fibreglass while the deck is made of fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

Both the hull and the deck is a sandwich construction which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin.


Interior

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with one cabin, 3 berths, a galley, 100.0 liter fresh water capacity and toilet facility.


Keel

Unknown keel type

The boat can enter even shallow marinas as the draft is just about 0.80 - 0.90 meter (2.62 - 2.92 ft) dependent on the load. See immersion rate below.


Engine

Scand 8600 Dynamic may be equipped with an inboard Volvo Penta AQ AD41 DP engine at 200 hp (149 kW). Max speed is 32.0 knots.

The transmission is a Z-drive aka sterndrive.

The fuel tank, which is made of aluminium, has a capacity of 350.0 liters (92 US gallons, 76 imperial gallons).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Scand 8600 Dynamic is about 180 kg/cm, alternatively 1012 lbs/inch.
Meaning: if you load 180 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1012 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Scand 8600 Dynamic is 3.04.

Wide Slim 54% 0 50 100
Compared with other similar motor boats it is slimmer than 54% of all other designs. It seems that the designer has chosen a slightly more speedy hull design.


Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Equation for Danish definition of a powerboat
Danish definition of a powerboat
According to this definition this boat is categorized as a Powerboat.


Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Scand 8600 Dynamic it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References