Review of Beeldsnijder 42
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Beeldsnijder 42 or similar boat for sale
The Beeldsnijder 42 is equipped with a ketch rig. A ketch rig is generally considered easier to handle, because the sails are smaller, and because it can sail on most points to the wind with one sail completely taken down for repair or while reefing. The sail configuration of a ketch allows for better comfort and stability when sailing downwind or on a broad reach.
Full keel
The Beeldsnijder 42 is equipped with a long keel. A full keel provide a better directional stability than a similar boat with a fin keel; on the other hand, better directional stability means also that the boat is more difficult to handle in a harbour with less space.
The boat can enter most marinas as the draft is just about 1.60 - 1.70 meter (5.25 - 5.55 ft) dependent on the load. See immersion rate below.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Beeldsnijder 42 is 1.57, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Beeldsnijder 42 is about 309 kg/cm, alternatively 1732 lbs/inch.
Meaning: if you load 309 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1732 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Beeldsnijder 42 is 3.47.
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 12.7 m | (41.5 feet) | 14 mm | (0.55 inch) |
| Genoa sheet | 12.7 m | (41.5 feet) | 14 mm | (0.55 inch) |
| Mainsheet | 31.6 m | (103.8 feet) | 14 mm | (0.55 inch) |
| Spinnaker sheet | 27.8 m | (91.3 feet) | 14 mm | (0.55 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Beeldsnijder 42 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.