YachtDatabase.com

Review of Hanse 575


Basic specs.

sail specifications
The Hanse 575 is a large sailboat designed by the German maritime architect bureau judel / vrolijk & co - engineering GmbH.

Here we would have liked to show you nice photos of the Hanse 575.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Hanse 575 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.


Interior

The boat is equipped with 810.0 liter fresh water capacity.


Rig

The Hanse 575 is equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a gennaker or a spinnaker for optimal speed.


Keel

The Hanse 575 has been built with different keel alternatives.

Torpedo keel

But be aware that even though a T keel is very good for speed racing, a fishing nets and the like in the water can easily make you into a troublesome situation.

The keel is made of iron. Many people prefer lead keel in favour of iron. The main argument is that lead is much heavier than iron and a lead keel can therefore be made smaller which again result in less wet surface, i.e. less drag. In fact iron is quite heavy, just 30% less heavy than lead, so the advantage of a lead keel is often overstated.

The boat can only enter major marinas as the draft is about 2.85 - 2.95 meter (9.35 - 9.65 ft) dependent on the load. See immersion rate below.

L-shape fin keel

One option is a L keel. An L-shape keel is a bulb keel with the shape as an L. This keel is less exposed to seaweed, fishing nets and lines.

This keel is also made of iron.

Hanse 575 can only enter major marinas as the draft is about 2.25 - 2.35 meter (7.38 - 7.68 ft) dependent on the load. See immersion rate below.


Engine

The boat may be equipped with an inboard Volvo Penta D3-110 diesel engine at 107 hp (79 kW).

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.

The fuel tank has a capacity of 520.0 liters (137 US gallons, 114 imperial gallons).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

EU classification

Hanse 575 holds a CE certification:

The boat is by European Union certified as Class A. OCEAN:
Designed for extended voyages where conditions may exceed wind force 8 (Beaufort scale) and significant wave heights of 4 m and above but excluding abnormal conditions, and vessels largely self-sufficient.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 9.4 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Hanse 575 is about 527 kg/cm, alternatively 2955 lbs/inch.
Meaning: if you load 527 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 2955 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Hanse 575 is 3.21.

Slim Wide 90% 0 50 100
Compared with other similar sailboats it is more spacy than 90% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Hanse 575 is 30%.

Low High 18% 0 50 100
This ballast ratio shows a righting moment that is higher than 18% of all similar sailboat designs. A righting moment (ability to resist heeling) significantly below average.


Over- / underrigged


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 91m2 (979 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for fractional rig.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 53.8 m(176.5 feet)14 mm(0.55 inch)
Jib/genoa halyard53.8 m(176.5 feet)14 mm(0.55 inch)
Spinnaker halyard53.8 m(176.5 feet)14 mm(0.55 inch)
Jib sheet 16.7 m(54.8 feet)16 mm(5/8 inch)
Genoa sheet16.7 m(54.8 feet)16 mm(5/8 inch)
Mainsheet 41.8 m(137.0 feet)16 mm(5/8 inch)
Spinnaker sheet36.7 m(120.5 feet)16 mm(5/8 inch)
Cunningham7.1 m(23.3 feet)14 mm(0.55 inch)
Kickingstrap14.2 m(46.6 feet)14 mm(0.55 inch)
Clew-outhaul14.2 m(46.6 feet)14 mm(0.55 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Hanse 575 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References