Review of Furia 1040

Basic specs.

The Furia 1040 is a sailboat designed by the French maritime architect Michel Joubert together with Bernard Nivelt also from France. The Furia 1040 is built by Dresport.

Here we would have liked to show you nice photos of the Furia 1040.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Furia 1040 or similar boat for sale

Keel

Unknown keel type

The boat can enter most marinas as the draft is just about 1.56 - 1.66 meter (5.12 - 5.42 ft) dependent on the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Furia 1040 is about 233 kg/cm, alternatively 1307 lbs/inch.
Meaning: if you load 233 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1307 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Furia 1040 is 2.77.

Compared with other similar sailboats it is more spacy than 85% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.

Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Jib sheet	9.8 m	(32.2 feet)	12 mm	(1/2 inch)
Genoa sheet	9.8 m	(32.2 feet)	12 mm	(1/2 inch)
Mainsheet	24.6 m	(80.5 feet)	12 mm	(1/2 inch)
Spinnaker sheet	21.6 m	(70.9 feet)	12 mm	(1/2 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Furia 1040 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.