Review of Draco 2100 SC

Basic specs.

The Draco 2100 SC is a small motorboat designed by the Norwegian maritime architect Kåre Drangsholt in the mid eighties. The Draco 2100 SC is built by the Norwegian yard Draco.

Here we would have liked to show you nice photos of the Draco 2100 SC.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Draco 2100 SC or similar boat for sale

Hull

The hull is made of hand laid fibreglass while the deck is made of fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

Interior

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with one cabin, 4 berths, a galley, 60.0 liter fresh water capacity and toilet facility.

Keel

Unknown keel type

The boat can enter even shallow marinas as the draft is just about 0.50 - 0.60 meter (1.64 - 1.94 ft) dependent on the load. See immersion rate below.

Engine

The Draco 2100 SC has been equipped with different engine alternatives.

Alternative 1:

Draco 2100 SC may be equipped with an inboard Volvo Penta engine

The transmission is a Z-drive aka sterndrive.

Alternative 2:

The boat may be equipped with an inboard MerCruiser engine at 130 hp (96 kW). The speed is 35.0 knots.

The transmission is a Z-drive aka sterndrive.

The fuel tank, which is made of stainless steel, has a capacity of 200.0 liters (52 US gallons, 43 imperial gallons).

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Draco 2100 SC is about 101 kg/cm, alternatively 566 lbs/inch.
Meaning: if you load 101 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 566 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Draco 2100 SC is 2.51.

Compared with other similar motor boats it is more spacy than 73% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.

Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Danish definition of a powerboat

According to this definition this boat is not categorized as a Powerboat.
Though, if you install a motor of 40 kW (54 hp), then the boat will become a powerboat, and you will need a Danish 'powerboat driving license'

Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Draco 2100 SC it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.