Review of Naples Sabot

Basic specs.

The Naples Sabot is a small sailing dinghy designed by the maritime architect Roy McCullough together with R. A. Violette in the early forties. Several thousand boats have been produced.

Here we would have liked to show you nice photos of the Naples Sabot.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Naples Sabot or similar boat for sale

Hull

The hull is made of plywood.
Some boats has a hull made of Fibreglass.

Interior

Note: the boat has also been sold to be self-made/-interiored, which means that the quality of each boat may vary.

Rig

The boat equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a genaker or a spinnaker for optimal speed.

Keel

Unknown keel type

The boat can sail close to the beach as the draft is just 0.13 - 0.23 meter (0.43 - 0.73 ft) dependent of the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Naples Sabot is about 17 kg/cm, alternatively 99 lbs/inch.
Meaning: if you load 17 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 99 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Naples Sabot is 1.93.

Sorry, we do not have sufficient statistical information available for this boat to provide a significant reliable analysis.

Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Naples Sabot it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.