The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.
The boat is equipped with 6 berths, a galley, 350.0 liter fresh water capacity, toilet facility and 120.0 liter waste water capacity.
The Comfortina 42 has been built with different keel alternatives.
Unknown keel type
The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.
The boat can only enter major marinas as the draft is about 2.10 - 2.20 meter (6.89 - 7.19 ft) dependent on the load. See immersion rate below.
Fin keel
The Comfortina 42 is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.
Comfortina 42 can only enter major marinas as the draft is about 2.10 - 2.20 meter (6.89 - 7.19 ft) dependent on the load. See immersion rate below.
The boat may be equipped with an inboard Yanmar 4JH3E diesel engine at 50 hp (37 kW). Calculated max speed is about 7.2 knots
The transmission is a saildrive.
The fuel tank has a capacity of 150.0 liters (39 US gallons, 32 imperial gallons).
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Comfortina 42 is 1.85, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
What is Theoretical Maximum Hull Speed?
The theoretical maximal speed of a displacement boat of this length is 8.2 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Comfortina 42 is about 296 kg/cm, alternatively 1661 lbs/inch.
Meaning: if you load 296 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1661 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is Motion Comfort Ratio (MCR)?
The Motion Comfort Ratio for Comfortina 42 is 27.1.
What is L/B (Length Beam Ratio)?
The l/b ratio for Comfortina 42 is 3.37.
The ballast ratio for Comfortina 42 is 32%.
What is Displacement Length Ratio?
The DL-ratio for Comfortina 42 is 168 which categorizes this boat among 'light racers'.
What is SA/D (Sail Area Displacement ratio)?
The SA/D for Comfortina 42 with ISO 8666 reference sail is 17.2, with a 135% genua the SA/D is 20.1.
When buying anti-fouling bottom paint, it's nice to know how much to buy.
The surface of the wet bottom is about 51m2 (548 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.
Note: If you use a paint roller you will need more paint than if you use a paintbrush.
Dimensions of sail.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
Usage | Length | Diameter | ||
Mainsail halyard | 38.8 m | (127.3 feet) | 12 mm | (1/2 inch) |
Jib/genoa halyard | 38.8 m | (127.3 feet) | 12 mm | (1/2 inch) |
Spinnaker halyard | 38.8 m | (127.3 feet) | 12 mm | (1/2 inch) |
Jib sheet | 13.0 m | (42.5 feet) | 14 mm | (0.55 inch) |
Genoa sheet | 13.0 m | (42.5 feet) | 14 mm | (0.55 inch) |
Mainsheet | 32.4 m | (106.3 feet) | 14 mm | (0.55 inch) |
Spinnaker sheet | 28.5 m | (93.5 feet) | 14 mm | (0.55 inch) |
Cunningham | 5.0 m | (16.4 feet) | 12 mm | (1/2 inch) |
Kickingstrap | 10.0 m | (32.8 feet) | 12 mm | (1/2 inch) |
Clew-outhaul | 10.0 m | (32.8 feet) | 12 mm | (1/2 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Comfortina 42 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.