Review of Scampi 34
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Scampi 34 or similar boat for sale
The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with a galley.
Unknown keel type
The boat can only enter major marinas as the draft is about 1.80 - 1.90 meter (5.91 - 6.21 ft) dependent on the load. See immersion rate below.
Scampi 34 may be equipped with an inboard Farymann engine
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Scampi 34 is 1.95, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Scampi 34 is about 227 kg/cm, alternatively 1275 lbs/inch.
Meaning: if you load 227 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1275 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Scampi 34 is 3.12.
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 10.3 m | (33.8 feet) | 12 mm | (1/2 inch) |
| Genoa sheet | 10.3 m | (33.8 feet) | 12 mm | (1/2 inch) |
| Mainsheet | 25.8 m | (84.5 feet) | 12 mm | (1/2 inch) |
| Spinnaker sheet | 22.7 m | (74.3 feet) | 12 mm | (1/2 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Scampi 34 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.