Review of Princess 388 (1981)

Basic specs.

The Princess 388 (1981) is a motorboat designed by the British maritime architect John A. Bennet in the early eighties. The Princess 388 (1981) is built by the British yard Marine Projects.

Here we would have liked to show you nice photos of the Princess 388 (1981).
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Princess 388 (1981) or similar boat for sale

Hull

The hull is made of hand laid fibreglass while the deck is made of fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season.
The hull is a double hull which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin.

Interior

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with 3 cabins, 8 berths, a galley, 482.0 liter fresh water capacity and toilet facility.

Engine

The boat may be equipped with dual inboard Volvo Penta TAMD 41 diesel engines at 400 hp (298 kW). Max speed is 25.0 knots.

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.

The fuel tank, which is made of stainless steel, has a capacity of 1091.0 liters (288 US gallons, 239 imperial gallons).

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Princess 388 (1981) is about 330 kg/cm, alternatively 1848 lbs/inch.
Meaning: if you load 330 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1848 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Princess 388 (1981) is 2.87.

Compared with other similar motor boats it is more spacy than 79% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.

Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Danish definition of a powerboat

According to this definition this boat is categorized as a Powerboat.

Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Princess 388 (1981) it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.