YachtDatabase.com

Review of Monark 540


Monark 540
Monark 540.

Basic specs.

sail specifications
The Monark 540 is a small sailboat designed by the Swedish maritime architect Pelle Petterson in the early seventies. A few hundred boats have been produced. The Monark 540 is built by the Swedish yard Monark-Crescent AB.

Looking for a new boat? Find a Monark 540 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.


Interior

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with one cabin and 4 berths.


Rig

The Monark 540 is equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a gennaker or a spinnaker for optimal speed.


Keel
Keel
Keel of Monark 540.

Fin keel

The Monark 540 is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.

The keel is made of iron. Many people prefer lead keel in favour of iron. The main argument is that lead is much heavier than iron and a lead keel can therefore be made smaller which again result in less wet surface, i.e. less drag. In fact iron is quite heavy, just 30% less heavy than lead, so the advantage of a lead keel is often overstated. As the surface of a fin type keel is just a fraction of the total wet surface, the difference between an iron keel and a lead keel can in reality be ignored for cruising yachts.

The boat can enter even shallow marinas as the draft is just about 0.95 - 1.05 meter (3.12 - 3.42 ft) dependent on the load. See immersion rate below.


Engine

An outboard motor is often used on this boat. In that case Monark 540 will typically require a power of 2 - 3 hp, alternatively 35 - 42 lbs thrust if you prefer an electrical motor. Electric outboards are becoming popular for sailboat owners who want clean instant power with less noise and no exhaust fumes.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Monark 540 is 2.17, indicating that this boat would not be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 5.3 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Monark 540 is about 64 kg/cm, alternatively 360 lbs/inch.
Meaning: if you load 64 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 360 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Monark 540 is 13.5.

Low High 82% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 82% of all similar sailboat designs. This is a comfort value significantly above average.


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Monark 540 is 2.70.

Wide Slim 58% 0 50 100
Compared with other similar sailboats it is slimmer than 58% of all other designs. It seems that the designer has chosen a slightly more speedy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Monark 540 is 50%.

Low High 93% 0 50 100
This ballast ratio shows a righting moment that is higher than 93% of all similar sailboat designs. A righting moment (ability to resist heeling) significantly above average.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Monark 540 is 201 which categorizes this boat among 'light crusers & offshore racers'.

Heavy Light 31% 0 50 100
31% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Monark 540 with ISO 8666 reference sail is 16.6, with a 135% genua the SA/D is 19.1.

Low High 38% 0 50 100
The SA/D ratio indicates that it is faster than 38% of all similar sailboat designs in light wind.


Over- / underrigged

Low High 38% 0 50 100
The Monark 540 has more rig than 38% of all similar sailboats, which indicates that the boat is slightly underrigged.


RSP (Relative Speed Performance)

What is Relative Speed Performance?

The Relative Speed Performance for Monark 540 is 24

Slow Fast 24% 0 50 100
The relative speed performance is 24 which means that a it is faster than 24% of all similar sailboat designs.


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 11m2 (118 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for fractional rig.

mainsail specifications genoa specifications spinnaker specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 18.3 m(60.0 feet)6 mm(1/4 inch)
Jib/genoa halyard18.3 m(60.0 feet)6 mm(1/4 inch)
Spinnaker halyard18.3 m(60.0 feet)6 mm(1/4 inch)
Jib sheet 5.4 m(17.7 feet)8 mm(5/16 inch)
Genoa sheet5.4 m(17.7 feet)8 mm(5/16 inch)
Mainsheet 13.5 m(44.3 feet)8 mm(5/16 inch)
Spinnaker sheet11.9 m(39.0 feet)8 mm(5/16 inch)
Cunningham2.3 m(7.5 feet)6 mm(1/4 inch)
Kickingstrap4.6 m(15.1 feet)6 mm(1/4 inch)
Clew-outhaul4.6 m(15.1 feet)6 mm(1/4 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Monark 540 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References