Review of Jutlandic 37 DS
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Jutlandic 37 DS or similar boat for sale
Both the hull and the deck is made of hand laid fibreglass. Generally, a hull made of hand laid fibreglass requires only a minimum of maintenance during the sailing season.
Both the hull and the deck is a sandwich construction which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin.
The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with 2 cabins, 5 berths, a galley, 220.0 liter fresh water capacity, toilet facility and 95.0 liter waste water capacity.
The boat may be equipped with an inboard Volvo Penta MD22L diesel engine at 50 hp (37 kW). The speed is 9.0 knots.
The transmission is a saildrive.
The fuel tank, which is made of stainless steel, has a capacity of 240.0 liters (63 US gallons, 52 imperial gallons).
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Jutlandic 37 DS is 1.81, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
What is Theoretical Maximum Hull Speed?
The theoretical maximal speed of a displacement boat of this length is 8.1 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Jutlandic 37 DS is about 264 kg/cm, alternatively 1479 lbs/inch.
Meaning: if you load 264 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1479 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is Motion Comfort Ratio (MCR)?
The Motion Comfort Ratio for Jutlandic 37 DS is 26.5.
What is L/B (Length Beam Ratio)?
The l/b ratio for Jutlandic 37 DS is 3.21.
What is Displacement Length Ratio?
The DL-ratio for Jutlandic 37 DS is 148 which categorizes this boat among 'ultra light racers'.
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
|---|---|---|---|---|
| Jib sheet | 11.3 m | (37.1 feet) | 14 mm | (0.55 inch) |
| Genoa sheet | 11.3 m | (37.1 feet) | 14 mm | (0.55 inch) |
| Mainsheet | 28.3 m | (92.8 feet) | 14 mm | (0.55 inch) |
| Spinnaker sheet | 24.9 m | (81.6 feet) | 14 mm | (0.55 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Jutlandic 37 DS it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.