Review of Hartley 16
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Hartley 16 or similar boat for sale
The hull is made of wood.
CentreBoard
The Hartley 16 is equipped with a centreboard keel. A centreboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.
The boat can sail close to the beach as the draft is just 0.23 - 0.33 meter (0.75 - 1.05 ft) dependent of the load. See immersion rate below.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Hartley 16 is 3.12, indicating that this boat would not be accepted to participate in ocean races.
What is Theoretical Maximum Hull Speed?
The theoretical maximal speed of a displacement boat of this length is 5.0 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Hartley 16 is about 62 kg/cm, alternatively 352 lbs/inch.
Meaning: if you load 62 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 352 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is Motion Comfort Ratio (MCR)?
The Motion Comfort Ratio for Hartley 16 is 5.9.
What is L/B (Length Beam Ratio)?
The l/b ratio for Hartley 16 is 2.27.
What is Displacement Length Ratio?
The DL-ratio for Hartley 16 is 128 which categorizes this boat among 'ultra light racers'.
Maintenance
When buying anti-fouling bottom paint, it's nice to know how much to buy.
The surface of the wet bottom is about 11m2 (118 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.
Note: If you use a paint roller you will need more paint than if you use a paintbrush.
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
|---|---|---|---|---|
| Jib sheet | 5.0 m | (16.4 feet) | 8 mm | (5/16 inch) |
| Genoa sheet | 5.0 m | (16.4 feet) | 8 mm | (5/16 inch) |
| Mainsheet | 12.5 m | (41.0 feet) | 8 mm | (5/16 inch) |
| Spinnaker sheet | 11.0 m | (36.1 feet) | 8 mm | (5/16 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Hartley 16 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.