YachtDatabase.com

Review of Brise de Mer 39


Basic specs.

sail specifications
The Brise de Mer 39 is a sailboat designed by the French maritime architect bureau Groupe Finot in the mid eighties. Only a few boats have been produced.

Here we would have liked to show you nice photos of the Brise de Mer 39.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Brise de Mer 39 or similar boat for sale

Hull

The hull is made of aluminium. Aluminum is strong and forgiving. Where an impact on a fiberglass hull will result in major gelcoat damage and possible cracking, an aluminum hull will probably only have a scratch or a small bend. The only concern is electrolysis. Ensure that you have proper sacrificial anodes installed.


Keel

Unknown keel type

The boat can enter even shallow marinas as the draft is just about 0.55 - 0.65 meter (1.80 - 2.10 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Brise de Mer 39 is 2.05, indicating that this boat would not be accepted to participate in ocean races.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Brise de Mer 39 is about 295 kg/cm, alternatively 1651 lbs/inch.
Meaning: if you load 295 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1651 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Brise de Mer 39 is 3.22.

Slim Wide 58% 0 50 100
Compared with other similar sailboats it is more spacy than 58% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Brise de Mer 39 is 40%.

Low High 54% 0 50 100
This ballast ratio shows a righting moment that is higher than 54% of all similar sailboat designs. A righting moment (ability to resist heeling) just above average.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 11.9 m(39.0 feet)14 mm(0.55 inch)
Genoa sheet 11.9 m(39.0 feet)14 mm(0.55 inch)
Mainsheet 29.8 m(97.6 feet)14 mm(0.55 inch)
Spinnaker sheet26.2 m(85.9 feet)14 mm(0.55 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Brise de Mer 39 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References