Review of Winner 950
Basic specs.
Looking for a new boat? Find a Winner 950 or similar boat for sale
The Winner 950 is equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a gennaker or a spinnaker for optimal speed.
The Winner 950 has been built with different keel alternatives.
Unknown keel type
The boat can enter most marinas as the draft is just about 1.74 - 1.84 meter (5.71 - 6.01 ft) dependent on the load. See immersion rate below.
Unknown keel type
The boat can enter most marinas as the draft is just about 1.70 - 1.80 meter (5.58 - 5.88 ft) dependent on the load. See immersion rate below.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Winner 950 is about 199 kg/cm, alternatively 1119 lbs/inch.
Meaning: if you load 199 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1119 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Winner 950 is 3.04.
Maintenance
Dimensions of sail for fractional rig.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Mainsail halyard | 29.3 m | (96.1 feet) | 10 mm | (3/8 inch) |
| Jib/genoa halyard | 29.3 m | (96.1 feet) | 10 mm | (3/8 inch) |
| Spinnaker halyard | 29.3 m | (96.1 feet) | 10 mm | (3/8 inch) |
| Jib sheet | 9.5 m | (31.3 feet) | 12 mm | (1/2 inch) |
| Genoa sheet | 9.5 m | (31.3 feet) | 12 mm | (1/2 inch) |
| Mainsheet | 23.8 m | (78.2 feet) | 12 mm | (1/2 inch) |
| Spinnaker sheet | 21.0 m | (68.8 feet) | 12 mm | (1/2 inch) |
| Cunningham | 4.3 m | (14.1 feet) | 10 mm | (3/8 inch) |
| Kickingstrap | 8.6 m | (28.2 feet) | 10 mm | (3/8 inch) |
| Clew-outhaul | 8.6 m | (28.2 feet) | 10 mm | (3/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Winner 950 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.