YachtDatabase.com

Review of Wiking Boat 28


Wiking Boat 28
Wiking Boat 28 anno 1979. Fra sensommeren 2021 i Fredericia gl. havn.

Basic specs.

sail specifications
The Wiking Boat 28 also known as Wikingboat Family 28 or Wikingboat Family 28 is a motorboat designed by the Norwegian maritime architect Alf Jensen in the mid seventies. The Wiking Boat 28 is built by the Norwegian yard Wiking Boat A/S.

Looking for a new boat? Find a Wiking Boat 28 or similar boat for sale

Hull

The hull is made of plastic.


Interior

The interior is like most other boats made of teak. Teak has the advantage of being naturally very oily and therefore water-repellent, which is suitable on boats.
The boat is equipped with 3 cabins, 6 berths, a galley, 100.0 liter fresh water capacity, toilet facility and 130.0 liter waste water capacity.


Keel

Unknown keel type

The boat can enter even shallow marinas as the draft is just about 0.80 - 0.90 meter (2.62 - 2.92 ft) dependent on the load. See immersion rate below.


Engine

The Wiking Boat 28 has been equipped with different engine alternatives.

Alternative 1:

Wiking Boat 28 may be equipped with an inboard Volvo Penta TMD 40 diesel engine at 150 hp (111 kW). Max speed is 24.0 knots.

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.

Alternative 2:

The boat may be equipped with an inboard SAAB engine

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.

Alternative 3:

The boat may be equipped with an inboard Ford engine

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.

The fuel tank has a capacity of 360.0 liters (95 US gallons, 79 imperial gallons).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Wiking Boat 28 is about 182 kg/cm, alternatively 1023 lbs/inch.
Meaning: if you load 182 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1023 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Wiking Boat 28 is 2.75.

Slim Wide 85% 0 50 100
Compared with other similar motor boats it is more spacy than 85% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


Curiosities

Powerboat?

In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:

Equation for Danish definition of a powerboat
Danish definition of a powerboat
According to this definition this boat is categorized as a Powerboat.


Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Wiking Boat 28 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References