The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
The boat is equipped with 5 berths.
The Sirius 26 is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.
Fin keel
The Sirius 26 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a full keel.
The boat can enter even shallow marinas as the draft is just about 1.25 - 1.35 meter (4.10 - 4.40 ft) dependent on the load. See immersion rate below.
Sirius 26 may be equipped with an inboard engine
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Sirius 26 is 2.17, indicating that this boat would not be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Sirius 26 is about 136 kg/cm, alternatively 762 lbs/inch.
Meaning: if you load 136 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 762 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Sirius 26 is 2.69.
The ballast ratio for Sirius 26 is 44%.
What is SA/D (Sail Area Displacement ratio)?
The SA/D for Sirius 26 with ISO 8666 reference sail is 16.1, with a 135% genua the SA/D is 19.4.
Dimensions of sail for masthead rig.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
Usage | Length | Diameter | ||
Mainsail halyard | 21.3 m | (69.9 feet) | 8 mm | (5/16 inch) |
Jib/genoa halyard | 21.3 m | (69.9 feet) | 8 mm | (5/16 inch) |
Spinnaker halyard | 21.3 m | (69.9 feet) | 8 mm | (5/16 inch) |
Jib sheet | 7.4 m | (24.2 feet) | 10 mm | (3/8 inch) |
Genoa sheet | 7.4 m | (24.2 feet) | 10 mm | (3/8 inch) |
Mainsheet | 18.5 m | (60.6 feet) | 10 mm | (3/8 inch) |
Spinnaker sheet | 16.3 m | (53.3 feet) | 10 mm | (3/8 inch) |
Cunningham | 2.8 m | (9.0 feet) | 8 mm | (5/16 inch) |
Kickingstrap | 5.5 m | (18.0 feet) | 8 mm | (5/16 inch) |
Clew-outhaul | 5.5 m | (18.0 feet) | 8 mm | (5/16 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Sirius 26 (Streuer) it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.