Review of CDE 850 Racer
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a CDE 850 Racer or similar boat for sale
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
The hull is a double hull which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin.
The boat is equipped with 4 berths, a galley and toilet facility.
The CDE 850 Racer has been built with different keel alternatives.
Unknown keel type
The boat can only enter major marinas as the draft is about 1.80 - 1.90 meter (5.91 - 6.21 ft) dependent on the load.
Unknown keel type
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for CDE 850 Racer is 2.51, indicating that this boat would not be accepted to participate in ocean races.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for CDE 850 Racer is 2.85.
What is Relative Speed Performance?
The Relative Speed Performance for CDE 850 Racer is 100
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 8.5 m | (28.0 feet) | 10 mm | (3/8 inch) |
| Genoa sheet | 8.5 m | (28.0 feet) | 10 mm | (3/8 inch) |
| Mainsheet | 21.3 m | (70.0 feet) | 10 mm | (3/8 inch) |
| Spinnaker sheet | 18.8 m | (61.6 feet) | 10 mm | (3/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for CDE 850 Racer it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.