Review of Barberis 51

Basic specs.

The Barberis 51 is a large sailboat designed by the French maritime architect bureau Groupe Finot in the late nineties. Only a few boats have been produced.

Here we would have liked to show you nice photos of the Barberis 51.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Barberis 51 or similar boat for sale

Keel

Unknown keel type

The boat can only enter major marinas as the draft is about 2.35 - 2.45 meter (7.71 - 8.01 ft) dependent on the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Barberis 51 is 2.00, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Barberis 51 is about 466 kg/cm, alternatively 2614 lbs/inch.
Meaning: if you load 466 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 2614 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Barberis 51 is 3.29.

Compared with other similar sailboats it is more spacy than 73% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.

Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Barberis 51 is 40%.

This ballast ratio shows a righting moment that is higher than 73% of all similar sailboat designs. A righting moment (ability to resist heeling) just above average.

Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

**Guiding dimensions of running rig**
Usage	Length		Diameter
Jib sheet	15.2 m	(49.7 feet)	16 mm	(5/8 inch)
Genoa sheet	15.2 m	(49.7 feet)	16 mm	(5/8 inch)
Mainsheet	37.9 m	(124.3 feet)	16 mm	(5/8 inch)
Spinnaker sheet	33.3 m	(109.4 feet)	16 mm	(5/8 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Barberis 51 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.