Review of Oyster 565
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find an Oyster 565 or similar boat for sale
The boat is equipped with 850.0 liter fresh water capacity.
The Oyster 565 has been built with different keel alternatives.
Unknown keel type
The boat can only enter major marinas as the draft is about 2.50 - 2.60 meter (8.20 - 8.50 ft) dependent on the load. See immersion rate below.
CentreBoard
The Oyster 565 is equipped with a centreboard keel. A centreboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.
Oyster 565 can enter most marinas as the draft is just about 1.64 - 1.74 meter (5.38 - 5.68 ft) dependent on the load. See immersion rate below.
The boat may be equipped with an inboard Volvo Penta D3-150 diesel engine at 150 hp (111 kW). Calculated max speed is about 8.8 knots
The fuel tank has a capacity of 1000.0 liters (264 US gallons, 219 imperial gallons).
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Oyster 565 is 1.75, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
What is Theoretical Maximum Hull Speed?
The theoretical maximal speed of a displacement boat of this length is 9.7 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Oyster 565 is about 544 kg/cm, alternatively 3048 lbs/inch.
Meaning: if you load 544 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 3048 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Oyster 565 is 3.38.
What is Displacement Length Ratio?
The DL-ratio for Oyster 565 is 176 which categorizes this boat among 'light racers'.
SA/D (Sail Area Displacement ratio)
Indicates how fast the boat is in light wind:
- Cruising Boats have ratios 10-15
- Cruiser-Racers have ratios 16-20
- Racers have ratios above 20
- High-Performance Racers have ratios above 24
Sail-area/displacement ratio (SA/D ratio): 18.79
Maintenance
When buying anti-fouling bottom paint, it's nice to know how much to buy.
The surface of the wet bottom is about 91m2 (979 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.
Note: If you use a paint roller you will need more paint than if you use a paintbrush.
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 17.2 m | (56.5 feet) | 16 mm | (5/8 inch) |
| Genoa sheet | 17.2 m | (56.5 feet) | 16 mm | (5/8 inch) |
| Mainsheet | 43.0 m | (141.2 feet) | 16 mm | (5/8 inch) |
| Spinnaker sheet | 37.9 m | (124.3 feet) | 16 mm | (5/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Oyster 565 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.