YachtDatabase.com

Review of Kingfisher III


Kingfisher III
Kingfisher III.

Basic specs.

sail specifications
The Kingfisher III is a small sailing dinghy designed by the American maritime architect Philip L. Rhodes in the early sixties.

Looking for a new boat? Find a Kingfisher III or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.


Rig

The Kingfisher III is equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a gennaker or a spinnaker for optimal speed.


Keel
Keel
Keel of Kingfisher III.

CentreBoard

The Kingfisher III is equipped with a centreboard keel. A centreboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.

The boat can sail close to the beach as the draft is just 0.20 - 0.30 meter (0.66 - 0.96 ft) dependent of the load. See immersion rate below.


Trailer
Boat on trailer
Kingfisher III on trailer. Kingfisher III with a fractional rig and sidelong seating interior. Notice mast location is different from the Kingfisher with the Sunfish rig.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Kingfisher III is about 30 kg/cm, alternatively 173 lbs/inch.
Meaning: if you load 30 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 173 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Kingfisher III is 2.56.

Wide Slim 58% 0 50 100
Compared with other similar dinghies it is slimmer than 58% of all other designs. It seems that the designer has chosen a slightly more speedy hull design.


Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Kingfisher III it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References