YachtDatabase.com

Review of Hanseat 42


Basic specs.

sail specifications
The Hanseat 42 is a large sailboat designed by the maritime architect Willy Asmus. The Hanseat 42 is built by the German yard Asmus Werft GmbH & Co KG.

Here we would have liked to show you nice photos of the Hanseat 42.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Hanseat 42 or similar boat for sale

Keel

Fin keel

The Hanseat 42 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a full keel.

The boat can only enter major marinas as the draft is about 1.90 - 2.00 meter (6.23 - 6.53 ft) dependent on the load. See immersion rate below.


Engine

The boat is typically equipped with an inboard engine

The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Hanseat 42 is about 341 kg/cm, alternatively 1913 lbs/inch.
Meaning: if you load 341 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1913 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Hanseat 42 is 3.19.

Slim Wide 66% 0 50 100
Compared with other similar sailboats it is more spacy than 66% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 12.8 m(41.8 feet)14 mm(0.55 inch)
Genoa sheet12.8 m(41.8 feet)14 mm(0.55 inch)
Mainsheet 31.9 m(104.6 feet)14 mm(0.55 inch)
Spinnaker sheet28.1 m(92.0 feet)14 mm(0.55 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Hanseat 42 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References