YachtDatabase.com

Review of Tortarolo 38


Basic specs.

sail specifications
The Tortarolo 38 is a large sailboat designed by the French maritime architect Daniel Tortarolo.

Here we would have liked to show you nice photos of the Tortarolo 38.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Tortarolo 38 or similar boat for sale

Keel

Unknown keel type

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can only enter major marinas as the draft is about 2.05 - 2.15 meter (6.73 - 7.03 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Tortarolo 38 is about 325 kg/cm, alternatively 1824 lbs/inch.
Meaning: if you load 325 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 1824 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Tortarolo 38 is 3.04.

Slim Wide 76% 0 50 100
Compared with other similar sailboats it is more spacy than 76% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Tortarolo 38 is 38%.

Low High 42% 0 50 100
This ballast ratio shows a righting moment that is higher than 42% of all similar sailboat designs. A righting moment (ability to resist heeling) just below average.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 12.2 m(39.9 feet)14 mm(0.55 inch)
Genoa sheet 12.2 m(39.9 feet)14 mm(0.55 inch)
Mainsheet 30.4 m(99.7 feet)14 mm(0.55 inch)
Spinnaker sheet26.8 m(87.8 feet)14 mm(0.55 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Tortarolo 38 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References