YachtDatabase.com

Review of OVNI 53


Basic specs.

sail specifications
The OVNI 53 is a large sailboat designed by the French maritime architect Philippe Briand. The OVNI 53 is built by the French yard SAS Alubat Chantier Naval.

Here we would have liked to show you nice photos of the OVNI 53.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find an OVNI 53 or similar boat for sale

Hull

The hull is made of aluminium. Aluminum is strong and forgiving. Where an impact on a fiberglass hull will result in major gelcoat damage and possible cracking, an aluminum hull will probably only have a scratch or a small bend. The only concern is electrolysis. Ensure that you have proper sacrificial anodes installed.


Keel

Unknown keel type

The boat can only enter major marinas as the draft is about 1.90 - 2.00 meter (6.23 - 6.53 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for OVNI 53 is about 562 kg/cm, alternatively 3151 lbs/inch.
Meaning: if you load 562 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 3151 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for OVNI 53 is 3.36.

Slim Wide 79% 0 50 100
Compared with other similar sailboats it is more spacy than 79% of all other designs. It seems that the designer has chosen a significantly more spacy hull design.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 16.8 m(55.1 feet)16 mm(5/8 inch)
Genoa sheet 16.8 m(55.1 feet)16 mm(5/8 inch)
Mainsheet 42.0 m(137.8 feet)16 mm(5/8 inch)
Spinnaker sheet37.0 m(121.3 feet)16 mm(5/8 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for OVNI 53 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References