Both the hull and the deck is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
The boat is equipped with 6 berths and a galley.
The Maxus 24 is equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a gennaker or a spinnaker for optimal speed.
CentreBoard
The Maxus 24 is equipped with a centreboard keel. A centreboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.
The boat can sail close to the beach as the draft is just 0.35 - 0.45 meter (1.15 - 1.45 ft) dependent of the load. See immersion rate below.
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Maxus 24 is 2.11, indicating that this boat would not be accepted to participate in ocean races.
Maxus 24 holds two CE certifications:
The boat is by European Union certified as Class B. OFFSHORE:The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Maxus 24 is about 128 kg/cm, alternatively 717 lbs/inch.
Meaning: if you load 128 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 717 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Maxus 24 is 2.82.
The ballast ratio for Maxus 24 is 15%.
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
Usage | Length | Diameter | ||
Jib sheet | 7.2 m | (23.6 feet) | 10 mm | (3/8 inch) |
Genoa sheet | 7.2 m | (23.6 feet) | 10 mm | (3/8 inch) |
Mainsheet | 18.0 m | (59.1 feet) | 10 mm | (3/8 inch) |
Spinnaker sheet | 15.8 m | (52.0 feet) | 10 mm | (3/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Maxus 24 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.