YachtDatabase.com

Review of Helmsman 47


Basic specs.

sail specifications
The Helmsman 47 is a large sailboat. The Helmsman 47 is built by the Swedish yard Aktiebolaget Helmsman Yacht Design.

Here we would have liked to show you nice photos of the Helmsman 47.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Helmsman 47 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.


Keel

Fin keel

The Helmsman 47 is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.

The boat can only enter major marinas as the draft is about 2.30 - 2.40 meter (7.55 - 7.85 ft) dependent on the load. See immersion rate below.


Engine

The boat may be equipped with an inboard Bukh DV36 diesel engine at 36 hp (26 kW).


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Helmsman 47 is 1.61, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Helmsman 47 is about 359 kg/cm, alternatively 2013 lbs/inch.
Meaning: if you load 359 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 2013 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Helmsman 47 is 4.16.

Wide Slim 99% 0 50 100
Compared with other similar sailboats it is slimmer than 99% of all other designs. It seems that the designer has chosen a significantly more speedy hull design. This type of design is also referred to as 'needle'.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Helmsman 47 is 42%.

Low High 82% 0 50 100
This ballast ratio shows a righting moment that is higher than 82% of all similar sailboat designs. A righting moment (ability to resist heeling) significantly above average.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 14.9 m(49.0 feet)16 mm(5/8 inch)
Genoa sheet14.9 m(49.0 feet)16 mm(5/8 inch)
Mainsheet 37.4 m(122.6 feet)16 mm(5/8 inch)
Spinnaker sheet32.9 m(107.9 feet)16 mm(5/8 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Helmsman 47 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References