YachtDatabase.com

Review of Christina 52


Basic specs.

sail specifications
The Christina 52 is a large sailboat designed by the American maritime architect Douglas Blair Peterson in the late eighties.

Here we would have liked to show you nice photos of the Christina 52.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Christina 52 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.


Keel

Fin keel

The Christina 52 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a full keel.

The boat can only enter major marinas as the draft is about 1.80 - 1.90 meter (5.91 - 6.21 ft) dependent on the load. See immersion rate below.


Engine

The boat may be equipped with an inboard Yanmar 4JH3-TE diesel engine at 75 hp (55 kW). Calculated max speed is about 7.4 knots


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Christina 52 is 1.78, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 8.6 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Christina 52 is about 358 kg/cm, alternatively 2005 lbs/inch.
Meaning: if you load 358 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 2005 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Christina 52 is 32.3.

Low High 42% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 42% of all similar sailboat designs. This comfort value is just below average.


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Christina 52 is 3.68.

Wide Slim 66% 0 50 100
Compared with other similar sailboats it is slimmer than 66% of all other designs. It seems that the designer has chosen a slightly more speedy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Christina 52 is 37%.

Low High 58% 0 50 100
This ballast ratio shows a righting moment that is higher than 58% of all similar sailboat designs. A righting moment (ability to resist heeling) just above average.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Christina 52 is 201 which categorizes this boat among 'light crusers & offshore racers'.

Heavy Light 58% 0 50 100
58% of all similar sailboat designs are categorized as heavier. A light displacement requires less sailarea and has higher accellerations.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Christina 52 with ISO 8666 reference sail is 17.4, with a 135% genua the SA/D is 20.7.

Low High 27% 0 50 100
The SA/D ratio indicates that it is faster than 27% of all similar sailboat designs in light wind.


Over- / underrigged


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 57m2 (613 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 41.7 m(136.7 feet)14 mm(0.55 inch)
Jib/genoa halyard41.7 m(136.7 feet)14 mm(0.55 inch)
Spinnaker halyard41.7 m(136.7 feet)14 mm(0.55 inch)
Jib sheet 15.7 m(51.5 feet)16 mm(5/8 inch)
Genoa sheet15.7 m(51.5 feet)16 mm(5/8 inch)
Mainsheet 39.2 m(128.8 feet)16 mm(5/8 inch)
Spinnaker sheet34.5 m(113.3 feet)16 mm(5/8 inch)
Cunningham5.8 m(19.0 feet)14 mm(0.55 inch)
Kickingstrap11.6 m(38.0 feet)14 mm(0.55 inch)
Clew-outhaul11.6 m(38.0 feet)14 mm(0.55 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Christina 52 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References