Review of Trave 15,4 m
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Trave 15,4 m or similar boat for sale
The boat is equipped with 6 berths.
Unknown keel type
The boat can enter most marinas as the draft is just about 1.70 - 1.80 meter (5.58 - 5.88 ft) dependent on the load. See immersion rate below.
Trave 15,4 m is typically equipped with an inboard diesel engine at 67 hp (49 kW).
The transmission is a shaft drive. A shaft drive will in the long run require less maintenance than other types of drive e.g. a sail drive.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Trave 15,4 m is 1.46, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Trave 15,4 m is about 412 kg/cm, alternatively 2308 lbs/inch.
Meaning: if you load 412 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 2308 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Trave 15,4 m is 3.85.
SA/D (Sail Area Displacement ratio)
Indicates how fast the boat is in light wind:
- Cruising Boats have ratios 10-15
- Cruiser-Racers have ratios 16-20
- Racers have ratios above 20
- High-Performance Racers have ratios above 24
Sail-area/displacement ratio (SA/D ratio): 12.82
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 15.4 m | (50.5 feet) | 16 mm | (5/8 inch) |
| Genoa sheet | 15.4 m | (50.5 feet) | 16 mm | (5/8 inch) |
| Mainsheet | 38.5 m | (126.1 feet) | 16 mm | (5/8 inch) |
| Spinnaker sheet | 33.8 m | (111.0 feet) | 16 mm | (5/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Trave 15,4 m it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.