YachtDatabase.com

Review of Dixie 27




Basic specs.

sail specifications
The Dixie 27 is a sailboat designed by the Swedish maritime architect Bernt Andersson in the late seventies. Less than 100 boats have been produced. The Dixie 27 is built by the Swedish yard CN Marin.

Here we would have liked to show you nice photos of the Dixie 27.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Dixie 27 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.


Interior

The boat is equipped with 5 berths.


Rig
Rig
Dixie 27 with spinnaker.

The boat has more than one rig.

One option is a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a gennaker or a spinnaker for optimal speed.

Another option is a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.


Keel

Fin keel

The Dixie 27 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a full keel.

The keel is made of iron. Many people prefer lead keel in favour of iron. The main argument is that lead is much heavier than iron and a lead keel can therefore be made smaller which again result in less wet surface, i.e. less drag. In fact iron is quite heavy, just 30% less heavy than lead, so the advantage of a lead keel is often overstated. As the surface of a fin type keel is just a fraction of the total wet surface, the difference between an iron keel and a lead keel can in reality be ignored for cruising yachts.

Dixie 27 can enter most marinas as the draft is just about 1.55 - 1.65 meter (5.09 - 5.39 ft) dependent on the load. See immersion rate below.


Engine

The boat may be equipped with an inboard Volvo Penta MD5 diesel engine at 7 hp (5 kW). Calculated max speed is about 3.9 knots


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Dixie 27 is 2.15, indicating that this boat would not be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 6.0 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Dixie 27 is about 115 kg/cm, alternatively 645 lbs/inch.
Meaning: if you load 115 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 645 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Dixie 27 is 18.1.

Low High 34% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 34% of all similar sailboat designs. This comfort value is just below average.


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Dixie 27 is 2.93.

Slim Wide 66% 0 50 100
Compared with other similar sailboats it is more spacy than 66% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Dixie 27 is 39%.

Low High 46% 0 50 100
This ballast ratio shows a righting moment that is higher than 46% of all similar sailboat designs. A righting moment (ability to resist heeling) just below average.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Dixie 27 is 282 which categorizes this boat among 'medium weight cruisers'.

Heavy Light 34% 0 50 100
34% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Dixie 27 with ISO 8666 reference sail is 14.0, with a 135% genua the SA/D is 16.8.

Low High 24% 0 50 100
The SA/D ratio indicates that it is faster than 24% of all similar sailboat designs in light wind.


Over- / underrigged

Low High 54% 0 50 100
The Dixie 27 has more rig than 54% of all similar sailboats, which indicates that the boat is slightly overrigged.


RSP (Relative Speed Performance)

What is Relative Speed Performance?

The Relative Speed Performance for Dixie 27 is 34

Slow Fast 34% 0 50 100
The relative speed performance is 34 which means that a it is faster than 34% of all similar sailboat designs.


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 20m2 (215 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for masthead rig.

mainsail specifications genoa specifications spinnaker specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
Masthead rig
UsageLengthDiameter
Mainsail halyard 21.8 m(71.5 feet)8 mm(5/16 inch)
Jib/genoa halyard21.8 m(71.5 feet)8 mm(5/16 inch)
Spinnaker halyard21.8 m(71.5 feet)8 mm(5/16 inch)
Jib sheet 8.3 m(27.1 feet)10 mm(3/8 inch)
Genoa sheet8.3 m(27.1 feet)10 mm(3/8 inch)
Mainsheet 20.7 m(67.8 feet)10 mm(3/8 inch)
Spinnaker sheet18.2 m(59.7 feet)10 mm(3/8 inch)
Cunningham2.5 m(8.1 feet)8 mm(5/16 inch)
Kickingstrap5.0 m(16.3 feet)8 mm(5/16 inch)
Clew-outhaul5.0 m(16.3 feet)8 mm(5/16 inch)
Fractional rig
UsageLengthDiameter
Mainsail halyard 24.1 m(79.1 feet)8 mm(5/16 inch)
Jib/genoa halyard24.1 m(79.1 feet)8 mm(5/16 inch)
Spinnaker halyard24.1 m(79.1 feet)8 mm(5/16 inch)
Jib sheet 8.3 m(27.1 feet)10 mm(3/8 inch)
Genoa sheet8.3 m(27.1 feet)10 mm(3/8 inch)
Mainsheet 20.7 m(67.8 feet)10 mm(3/8 inch)
Spinnaker sheet18.2 m(59.7 feet)10 mm(3/8 inch)
Cunningham2.8 m(9.2 feet)8 mm(5/16 inch)
Kickingstrap5.6 m(18.4 feet)8 mm(5/16 inch)
Clew-outhaul5.6 m(18.4 feet)8 mm(5/16 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Dixie 27 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References