Review of X-562
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a X-562 or similar boat for sale
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
The X-562 is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.
Fin keel
The X-562 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a full keel.
The boat can only enter major marinas as the draft is about 2.85 - 2.95 meter (9.35 - 9.65 ft) dependent on the load.
The boat may be equipped with an inboard Yanmar 4JH3-THE diesel engine at 100 hp (74 kW).
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
Sorry, we have no sailing characteristics available for this boat.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
Sorry, we do not have sufficient statistical information available for this boat to provide a significant reliable analysis.
Maintenance
Dimensions of sail for masthead rig.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Mainsail halyard | 52.3 m | (171.6 feet) | 6 mm | (1/4 inch) |
| Jib/genoa halyard | 52.3 m | (171.6 feet) | 6 mm | (1/4 inch) |
| Spinnaker halyard | 52.3 m | (171.6 feet) | 6 mm | (1/4 inch) |
| Cunningham | 6.6 m | (21.6 feet) | 6 mm | (1/4 inch) |
| Kickingstrap | 13.1 m | (43.1 feet) | 6 mm | (1/4 inch) |
| Clew-outhaul | 13.1 m | (43.1 feet) | 6 mm | (1/4 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for X-562 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.