Review of RM 1180
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a RM 1180 or similar boat for sale
The hull is made of plywood.
The boat is equipped with 268.0 liter fresh water capacity.
The RM 1180 is built with a cutter rig. A cutter rig breaks the yacht’s sail area down into smaller, easier to manage sails. Cutter rigs are often used for offshore sailing.
Fin keel
The RM 1180 is built with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a full keel.
The boat can only enter major marinas as the draft is about 2.25 - 2.35 meter (7.38 - 7.68 ft) dependent on the load. See immersion rate below.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for RM 1180 is 2.23, indicating that this boat would not be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for RM 1180 is about 345 kg/cm, alternatively 1934 lbs/inch.
Meaning: if you load 345 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1934 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for RM 1180 is 2.70.
SA/D (Sail Area Displacement ratio)
Indicates how fast the boat is in light wind:
- Cruising Boats have ratios 10-15
- Cruiser-Racers have ratios 16-20
- Racers have ratios above 20
- High-Performance Racers have ratios above 24
Sail-area/displacement ratio (SA/D ratio): 19.03
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 11.8 m | (38.7 feet) | 14 mm | (0.55 inch) |
| Genoa sheet | 11.8 m | (38.7 feet) | 14 mm | (0.55 inch) |
| Mainsheet | 29.5 m | (96.8 feet) | 14 mm | (0.55 inch) |
| Spinnaker sheet | 26.0 m | (85.2 feet) | 14 mm | (0.55 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for RM 1180 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.