YachtDatabase.com

Review of Gib'Sea 242 (CB)


Basic specs.

sail specifications
The Gib'Sea 242 (CB) is a small sailboat designed by the French maritime architect G. Graal. The Gib'Sea 242 (CB) is built by the French yard Gibert Marine.

Here we would have liked to show you nice photos of the Gib'Sea 242 (CB).
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Gib'Sea 242 (CB) or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.


Keel

Unknown keel type

The boat can enter most marinas as the draft is just about 1.64 - 1.74 meter (5.38 - 5.68 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Gib'Sea 242 (CB) is about 119 kg/cm, alternatively 667 lbs/inch.
Meaning: if you load 119 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 667 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Gib'Sea 242 (CB) is 2.87.

Slim Wide 58% 0 50 100
Compared with other similar sailboats it is more spacy than 58% of all other designs. It seems that the designer has chosen a slightly more spacy hull design.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 7.1 m(23.4 feet)10 mm(3/8 inch)
Genoa sheet 7.1 m(23.4 feet)10 mm(3/8 inch)
Mainsheet 17.8 m(58.6 feet)10 mm(3/8 inch)
Spinnaker sheet15.7 m(51.5 feet)10 mm(3/8 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Gib'Sea 242 (CB) it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References