Review of Clipper 48
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Clipper 48 or similar boat for sale
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.
The Clipper 48 has been built with different keel alternatives.
Unknown keel type
The boat can only enter major marinas as the draft is about 1.91 - 2.01 meter (6.27 - 6.57 ft) dependent on the load. See immersion rate below.
Full keel
The Clipper 48 is equipped with a long keel. A full keel provide a better directional stability than a similar boat with a fin keel; on the other hand, better directional stability means also that the boat is more difficult to handle in a harbour with less space.
The boat can only enter major marinas as the draft is about 1.83 - 1.93 meter (6.00 - 6.30 ft) dependent on the load. See immersion rate below.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Clipper 48 is about 388 kg/cm, alternatively 2175 lbs/inch.
Meaning: if you load 388 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 2175 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Clipper 48 is 3.66.
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
|---|---|---|---|---|
| Jib sheet | 14.6 m | (47.8 feet) | 16 mm | (5/8 inch) |
| Genoa sheet | 14.6 m | (47.8 feet) | 16 mm | (5/8 inch) |
| Mainsheet | 36.4 m | (119.5 feet) | 16 mm | (5/8 inch) |
| Spinnaker sheet | 32.1 m | (105.2 feet) | 16 mm | (5/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Clipper 48 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.