Review of Banner 26
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Banner 26 or similar boat for sale
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
Note: the boat has also been sold to be self-made/-interiored, which means that the quality of each boat may vary.
Unknown keel type
The boat can enter even shallow marinas as the draft is just about 1.27 - 1.37 meter (4.17 - 4.47 ft) dependent on the load. See immersion rate below.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
What is Capsize Screening Formula (CSF)?
The capsize screening value for Banner 26 is 2.22, indicating that this boat would not be accepted to participate in ocean races.
The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Banner 26 is about 122 kg/cm, alternatively 684 lbs/inch.
Meaning: if you load 122 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 684 lbs cargo on the boat it will sink 1 inch.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Banner 26 is 3.33.
What is Relative Speed Performance?
The Relative Speed Performance for Banner 26 is 62
Maintenance
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Jib sheet | 7.8 m | (25.6 feet) | 10 mm | (3/8 inch) |
| Genoa sheet | 7.8 m | (25.6 feet) | 10 mm | (3/8 inch) |
| Mainsheet | 19.5 m | (64.0 feet) | 10 mm | (3/8 inch) |
| Spinnaker sheet | 17.2 m | (56.3 feet) | 10 mm | (3/8 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Banner 26 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.