Review of Tanzer 10.5
Basic specs.
If you have a photo you would like to share: Upload Image
Looking for a new boat? Find a Tanzer 10.5 or similar boat for sale
The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
The Tanzer 10.5 is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.
The Tanzer 10.5 has been built with different keel alternatives.
Fin keel
The Tanzer 10.5 is equipped with a fin keel. A boat with a fin keel is more manoeuvrable but has less directional stability than a similar boat with a full keel.
The boat can only enter major marinas as the draft is about 1.80 - 1.90 meter (5.91 - 6.21 ft) dependent on the load.
DaggerBoard aka Sword
The Tanzer 10.5 is equipped with a daggerboard keel. A daggerboard is a lifting keel that can be lowered and raised, allowing the boat to enter shallow waters as well.
The boat can enter even shallow marinas as the draft is just about 0.63 - 0.73 meter (2.07 - 2.37 ft) dependent on the load.
Sailing characteristics
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
Sorry, we have no sailing characteristics available for this boat.
Sailing statistics
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
Sorry, we do not have sufficient statistical information available for this boat to provide a significant reliable analysis.
Maintenance
Dimensions of sail for masthead rig.
Are your sails worn out? You might find your next sail here: Sails for Sale
If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.
| Usage | Length | Diameter | ||
| Mainsail halyard | 30.1 m | (98.8 feet) | 6 mm | (1/4 inch) |
| Jib/genoa halyard | 30.1 m | (98.8 feet) | 6 mm | (1/4 inch) |
| Spinnaker halyard | 30.1 m | (98.8 feet) | 6 mm | (1/4 inch) |
| Cunningham | 4.0 m | (13.0 feet) | 6 mm | (1/4 inch) |
| Kickingstrap | 7.9 m | (26.0 feet) | 6 mm | (1/4 inch) |
| Clew-outhaul | 7.9 m | (26.0 feet) | 6 mm | (1/4 inch) |
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Tanzer 10.5 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.