YachtDatabase.com

Review of Semona


Semona
Semona anno 1972. La Dolce Vita for motor

Basic specs.

sail specifications
The Semona is a sailboat designed by the maritime architect Ingemar Nilsson.

Looking for a new boat? Find a Semona or similar boat for sale

Rig

The Semona is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.


Keel

Unknown keel type

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can enter even shallow marinas as the draft is just about 1.25 - 1.35 meter (4.10 - 4.40 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Semona is 1.96, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 6.4 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Semona is about 138 kg/cm, alternatively 774 lbs/inch.
Meaning: if you load 138 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 774 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Motion Comfort Ratio

What is Motion Comfort Ratio (MCR)?

The Motion Comfort Ratio for Semona is 23.0.

Low High 50% 0 50 100
Comparing this ratio with similar sailboats show that it is more comfortable than 50% of all similar sailboat designs. This is an average comfort value!


L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Semona is 3.08.

Slim Wide 50% 0 50 100
Compared with other similar sailboats it is more spacy than 50% of all other designs. It seems that the designer has chosen an average hull design.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Semona is 46%.

Low High 79% 0 50 100
This ballast ratio shows a righting moment that is higher than 79% of all similar sailboat designs. A righting moment (ability to resist heeling) significantly above average.


D/L (Displacement Length Ratio)

What is Displacement Length Ratio?

The DL-ratio for Semona is 284 which categorizes this boat among 'medium weight cruisers'.

Heavy Light 38% 0 50 100
38% of all similar sailboat designs are categorized as heavier. A heavy displacement combined with smaller water plane area has lower acceleration and is more comfortable.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Semona with ISO 8666 reference sail is 13.2, with a 135% genua the SA/D is 15.6.

Low High 18% 0 50 100
The SA/D ratio indicates that it is faster than 18% of all similar sailboat designs in light wind.


Over- / underrigged

Low High 50% 0 50 100
The Semona has more rig than 50% of all similar sailboats, which indicates that this rig is spot on average!


RSP (Relative Speed Performance)

What is Relative Speed Performance?

The Relative Speed Performance for Semona is 18

Slow Fast 18% 0 50 100
The relative speed performance is 18 which means that a it is faster than 18% of all similar sailboat designs.


Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 22m2 (236 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for masthead rig.

mainsail specifications genoa specifications spinnaker specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 24.9 m(81.8 feet)10 mm(3/8 inch)
Jib/genoa halyard24.9 m(81.8 feet)10 mm(3/8 inch)
Spinnaker halyard24.9 m(81.8 feet)10 mm(3/8 inch)
Jib sheet 9.1 m(29.9 feet)12 mm(1/2 inch)
Genoa sheet9.1 m(29.9 feet)12 mm(1/2 inch)
Mainsheet 22.8 m(74.6 feet)12 mm(1/2 inch)
Spinnaker sheet20.0 m(65.7 feet)12 mm(1/2 inch)
Cunningham3.0 m(9.8 feet)10 mm(3/8 inch)
Kickingstrap6.0 m(19.7 feet)10 mm(3/8 inch)
Clew-outhaul6.0 m(19.7 feet)10 mm(3/8 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Semona it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References