Both the hull and the deck is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.
Both the hull and the deck is a sandwich construction which improves the indoor climate. Especially when the water is colder than the air in the cabin, then the double hull insulates against cold water and reduce the condense water in the cabin. The core material in the sandwich construction is balsa.
The boat is equipped with 2 cabins, 5 berths, a galley, 200.0 liter fresh water capacity, toilet facility and 80.0 liter waste water capacity.
The Antarès 11 has been equipped with different engine alternatives.
Alternative 1:
The boat may be equipped with dual outboard Suzuki gasoline engines at 600 hp (447 kW). Max speed is 33.0 knots.
Alternative 2:
Antarès 11 may be equipped with dual outboard Mercury F250 XXL gasoline engines at 500 hp (372 kW).
The fuel tank has a capacity of 800.0 liters (211 US gallons, 175 imperial gallons).
This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.
Antarès 11 holds two CE certifications:
If less than 8 in on board the boat is by European Union certified as Class B. OFFSHORE:The immersion rate is defined as the weight required to sink the boat a certain level.
The immersion rate for Antarès 11 is about 262 kg/cm, alternatively 1469 lbs/inch.
Meaning: if you load 262 kg cargo on the boat then it will sink 1 cm.
Alternatively, if you load 1469 lbs cargo on the boat it will sink 1 inch.
This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.
What is L/B (Length Beam Ratio)?
The l/b ratio for Antarès 11 is 2.82.
In Denmark, you are required to have achieved a 'powerboat driving license' in order to sail a powerboat.
In this context a boat is considered a powerboat if:
As balsa wood is used as sandwich core material special care must be taken in relation to work that require penetration of the sandwich construction in order to to prevent water to get in contact with the balsa wood. Otherwise the balsa wood will eventually rotten and be expensive/impossible to repair.
This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.
Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.
We are always looking for new photos. If you can contribute with photos for Antarès 11 it would be a great help.
If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.