YachtDatabase.com

Review of X-35


Basic specs.

sail specifications
The X-35 is a sailboat designed in the mid 2000. A few hundred boats have been produced. The X-35 is built by the Danish yard X-Yachts A/S.

Here we would have liked to show you nice photos of the X-35.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a X-35 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.


Keel

Unknown keel type

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can only enter major marinas as the draft is about 2.15 - 2.25 meter (7.05 - 7.35 ft) dependent on the load.


Engine

The boat may be equipped with an inboard diesel engine


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Sorry, we have no sailing characteristics available for this boat.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

Sorry, we do not have sufficient statistical information available for this boat to provide a significant reliable analysis.

Maintenance

Rig

Dimensions of sail.

mainsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 36.9 m(121.1 feet)6 mm(1/4 inch)
Jib/genoa halyard36.9 m(121.1 feet)6 mm(1/4 inch)
Spinnaker halyard36.9 m(121.1 feet)6 mm(1/4 inch)
Cunningham4.9 m(16.1 feet)6 mm(1/4 inch)
Kickingstrap9.8 m(32.2 feet)6 mm(1/4 inch)
Clew-outhaul9.8 m(32.2 feet)6 mm(1/4 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for X-35 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References