YachtDatabase.com

Review of Valk Falcon


Basic specs.

sail specifications
The Valk Falcon is a small sailboat designed by the Dutch maritime architect E. G. van de Stadt in the early forties.

Here we would have liked to show you nice photos of the Valk Falcon.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Valk Falcon or similar boat for sale

Hull

The hull is made of plywood.


Keel

Full keel

The Valk Falcon is equipped with a long keel. A full keel provide a better directional stability than a similar boat with a fin keel; on the other hand, better directional stability means also that the boat is more difficult to handle in a harbour with less space.

The boat can enter even shallow marinas as the draft is just about 0.80 - 0.90 meter (2.62 - 2.92 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Valk Falcon is 2.78, indicating that this boat would not be accepted to participate in ocean races.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Valk Falcon is about 87 kg/cm, alternatively 487 lbs/inch.
Meaning: if you load 87 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 487 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Valk Falcon is 3.25.

Wide Slim 92% 0 50 100
Compared with other similar sailboats it is slimmer than 92% of all other designs. It seems that the designer has chosen a significantly more speedy hull design. This type of design is also referred to as 'needle'.


Ballast Ratio

What is a Ballast Ratio?

The ballast ratio for Valk Falcon is 39%.

Low High 54% 0 50 100
This ballast ratio shows a righting moment that is higher than 54% of all similar sailboat designs. A righting moment (ability to resist heeling) just above average.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 6.5 m(21.3 feet)10 mm(3/8 inch)
Genoa sheet 6.5 m(21.3 feet)10 mm(3/8 inch)
Mainsheet 16.2 m(53.3 feet)10 mm(3/8 inch)
Spinnaker sheet14.3 m(46.9 feet)10 mm(3/8 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Valk Falcon it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References