YachtDatabase.com

Review of Solaris 60


Basic specs.

sail specifications
The Solaris 60 is a large sailboat designed by the American maritime architect William Tripp, III in the late 2000.

Here we would have liked to show you nice photos of the Solaris 60.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Solaris 60 or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season.


Interior

The boat is equipped with 800.0 liter fresh water capacity.


Rig

The Solaris 60 is equipped with a fractional rig. A fractional rig has smaller headsails which make tacking easier, which is an advantage for cruisers and racers, of course. The downside is that having the wind from behind often requires a gennaker or a spinnaker for optimal speed.


Keel

Fin keel

The Solaris 60 is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.

The boat can only enter major marinas as the draft is about 3.30 - 3.40 meter (10.83 - 11.13 ft) dependent on the load. See immersion rate below.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Stability and Safety

What is Capsize Screening Formula (CSF)?

The capsize screening value for Solaris 60 is 1.80, indicating that this boat could - if evaluated by this formula alone - be accepted to participate in ocean races.


Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 10.0 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Solaris 60 is about 590 kg/cm, alternatively 3304 lbs/inch.
Meaning: if you load 590 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 3304 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Solaris 60 is 3.68.


SA/D (Sail Area Displacement ratio)

What is SA/D (Sail Area Displacement ratio)?

The SA/D for Solaris 60 with ISO 8666 reference sail is 25.3, with a 135% genua the SA/D is 29.4.


Over- / underrigged


Sorry, we do not have sufficient statistical information available for this boat to provide a significant reliable analysis.

Maintenance

Bottom Paint

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 108m2 (1162 ft2).
Based on this, your favourite maritime shop can tell you the quantity you need.

Note: If you use a paint roller you will need more paint than if you use a paintbrush.


Rig

Dimensions of sail for fractional rig.

mainsail specifications headsail specifications

Are your sails worn out? You might find your next sail here: Sails for Sale



If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Mainsail halyard 66.0 m(216.4 feet)14 mm(0.55 inch)
Jib/genoa halyard66.0 m(216.4 feet)14 mm(0.55 inch)
Spinnaker halyard66.0 m(216.4 feet)14 mm(0.55 inch)
Jib sheet 19.0 m(62.2 feet)16 mm(5/8 inch)
Genoa sheet19.0 m(62.2 feet)16 mm(5/8 inch)
Mainsheet 47.4 m(155.6 feet)16 mm(5/8 inch)
Spinnaker sheet41.7 m(136.9 feet)16 mm(5/8 inch)
Cunningham8.7 m(28.6 feet)14 mm(0.55 inch)
Kickingstrap17.5 m(57.3 feet)14 mm(0.55 inch)
Clew-outhaul17.5 m(57.3 feet)14 mm(0.55 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Solaris 60 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References