YachtDatabase.com

Review of Hallberg-Rassy P 28 Mk III




Basic specs.

sail specifications
The Hallberg-Rassy P 28 Mk III aka P 28 Mk III or HR P 28 Mk III aka HR P 28 Mk III is a sailboat designed by the Swedish maritime architect Harry Hallberg in the early seventies. Less than 100 boats have been produced. The Hallberg-Rassy P 28 Mk III is built by the Swedish yard Hallberg-Rassy Varvs AB.

Here we would have liked to show you nice photos of the Hallberg-Rassy P 28 Mk III.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Hallberg-Rassy P 28 Mk III or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.


Interior

The interior is like many other boats made of mahogany. Mahogany belongs to the hardwood species, known for being water-repellent and resistant to decay. It has an attractive wood grain and holds wood polish and varnish well.
The boat is equipped with 2 cabins, 4 + 1/2 berths, a galley, 65.0 liter fresh water capacity and toilet facility.


Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Theoretical Maximum Hull Speed

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 6.2 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.


Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Hallberg-Rassy P 28 Mk III is about 103 kg/cm, alternatively 577 lbs/inch.
Meaning: if you load 103 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 577 lbs cargo on the boat it will sink 1 inch.


Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Hallberg-Rassy P 28 Mk III is 3.85.

Wide Slim 98% 0 50 100
Compared with other similar sailboats it is slimmer than 98% of all other designs. It seems that the designer has chosen a significantly more speedy hull design. This type of design is also referred to as 'needle'.


Maintenance

Rig

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.



Guiding dimensions of running rig
UsageLengthDiameter
Jib sheet 9.0 m(29.7 feet)12 mm(1/2 inch)
Genoa sheet 9.0 m(29.7 feet)12 mm(1/2 inch)
Mainsheet 22.6 m(74.1 feet)12 mm(1/2 inch)
Spinnaker sheet19.9 m(65.2 feet)12 mm(1/2 inch)

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.



Finally

We are always looking for new photos. If you can contribute with photos for Hallberg-Rassy P 28 Mk III it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.



References