Review of Duster

Basic specs.

The Duster is a small sailing dinghy designed by the maritime architect Owen P. Merrill. Several hundred boats have been produced.

Here we would have liked to show you nice photos of the Duster.
If you have a photo you would like to share: Upload Image

Looking for a new boat? Find a Duster or similar boat for sale

Hull

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.
Some boats has a hull made of Wood.

Rig

The Duster is equipped with a cat rig. A cat rig (also called an una rig) is simple to manage as there is no standing rigging, often referred to as “unstayed”. With only one sail it can be single-handed quite easily. The downside is its upwind performance.

Keel

CentreBoard

The Duster is equipped with a centreboard keel. A centreboard keel is a pivoting lifting keel, allowing to sail both coastal and inland waters.

The boat can sail close to the beach as the draft is just 0.05 - 0.15 meter (0.16 - 0.46 ft) dependent of the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

Immersion rate

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for Duster is about 38 kg/cm, alternatively 215 lbs/inch.
Meaning: if you load 38 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 215 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

L/B (Length Beam Ratio)

What is L/B (Length Beam Ratio)?

The l/b ratio for Duster is 3.07.

Compared with other similar dinghies it is slimmer than 92% of all other designs. It seems that the designer has chosen a significantly more speedy hull design. This type of design is also referred to as 'needle'.

Maintenance

Boat owner's ideas

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

Finally

We are always looking for new photos. If you can contribute with photos for Duster it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us. Criticism helps us to improve.

References

[Ref 1]: ISO 8666 Small craft — Principal data.
[Ref 3]: ISO 12215-5 Small craft — Hull construction and scantlings.